Compatible
| Feature | |||||||||||||||||||||||||||||
| Description
Microchip's PICkit3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.
The MPLAB PICkit3 allows debugging and programming of PIC? and dsPIC? Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming?.
Features
Basic Debugger System
The debugger system can be configured to use standard ICSP communication for both programming and debugging functions.
CAUTION: Do not change hardware connections while the PICkit3 or target is powered.
Supported Devices
Refer to MPLAB IDE v8.76, the following devices are supported:
Debugger To Target Communication
Connecting the PICkit3 to the target board through standard ICSP interface using 6-pin connector. The programmer connector pinout is shown in the figure below:
PICkit3 Status LEDs
The Status LEDs indicate the status of the PICkit3.
| |||||||||||||||||||||||||||||
| Package | |||||||||||||||||||||||||||||
Packing List:
PIC KIT3 Programmer * 1
USB Cable * 1
6Pin ISCP Cable * 1
CD *1
|